MINN KOTA POWERDRIVE Mode D'emploi page 10

INSTALLING THE POWERDRIVE
2
c. Remove the Right Sideplate.
d. Swing the Left Sideplate out and away from the
Base Extrusion.
2c
3
e. Make sure that the Power Cables from the battery are
disconnected, or that the breaker,
if equipped, is "off".
WARNING
Make sure the motor is mounted on a level surface and is
not connected to a power source.
4
f. Place the mount as close to the centerline or keel of
the boat as possible. The motor can be installed on
either the Port or Starboard side of the boat based on
personal preference. Check placement with the motor
in the stowed and deployed positions. Review the
mounting considerations at the beginning of
the installation.
10 | minnkotamotors.com
2d
Right Sideplate Right Sideplate
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
Power Cables Power Cables
©2021 Johnson Outdoors Marine Electronics, Inc.
Deck of Boat
Keel