MINN KOTA POWERDRIVE Mode D'emploi page 30

CONTROLLING AUTOPILOT
CONTROLLING AUTOPILOT
Toggle AutoPilot On/Off
When the AutoPilot is on and the trolling motor is pulled out of the water to the stow position, the steering motor will continue to run.
Turn off the AutoPilot switch to stop the steering motor. If the switch is left on, the steering motor will shut off automatically after 10
seconds. The motor should not be stored in this condition for long periods as power is still being applied to all electronics. Always turn
the Autopilot switch off and disconnect your motor from the battery when storing your boat.
1
a. While the motor is running, AutoPilot can be
toggled on by pressing the AutoPilot Button located
at the top of the Motor control head.
b. While AutoPilot is on, drive the boat as desired.
CAUTION
When the AutoPilot is on and the trolling motor is pulled
out of the water to the stow position, the steering motor will
continue to run. Turn off the AutoPilot switch to stop the
motor. If the switch is left on, the steering motor will shut
off automatically after 10 seconds. The motor should not
be stored in this condition for long periods as power is still
being applied to all electronics. Always turn the Autopilot
switch off and disconnect your motor from the battery when
storing your boat.
c. To toggle AutoPilot off, press the AutoPilot
Button again.
30 | minnkotamotors.com
AutoPilot AutoPilot
Button Button
NOTICE:
After steering to a new direction, there is a short
delay before the direction is locked in to allow the compass
to stabilize. When broad speed changes are made, the
AutoPilot heading may change slightly. This is normal.
Possible Deviation Possible Deviation
due to Wind/Current due to Wind/Current
AutoPilot AutoPilot
Heading Heading
©2021 Johnson Outdoors Marine Electronics, Inc.