Sensor Wiring - Siemens SITRANS FUS1010 IP65 NEMA 4X Instructions De Service

3.6

Sensor Wiring

Connecting Sensors to the Transmitter
1. Open the transmitter top cover. Using a flat blade screwdriver, remove the Cable Strain
2. Observing the upstream and downstream orientation, attach the UP (upstream) and DN
3. Replace the Cable Strain Relief bracket. Close top cover.
4. Proceed to Commissioning (Page 47).
①
②
③
④
Figure 3-13
FUS1010 IP65 NEMA 4X & IP66 NEMA 7 Quick Start
Operating Instructions, 07/2014, A5E03086486-AD
Relief bracket (see figure below).
(downstream) cables to the sensors and make snug. Attach the other ends to the UP and
DN terminals of the flow meter (see figure below).
Transmitter Input Module
Sensor Cables Connected to Transmitter
Cable Strain Relief Bracket
To CH-2 DN
Sensor Cable Connections
⑤
To CH-2 UP
⑥
To CH-1 DN
⑦
To CH-1 UP
⑧
Channel 2
⑨
Channel 1
Connecting
3.6 Sensor Wiring
45