Angelo Po FX61 E3 Manuel D'installation Et Mode D'emploi page 89

KEY TO ALARM TABLE (Continued)
Alarm Fault
Maximum allowed
E09
temperature in chamber
exceeded
Electrical component
E10
compartment has
overheated
Electronic circuit board
E11
diagnostics tripped
E13
E14
The humidity probe has
E19
failed or is not properly
connected
Setup error
E20
The washing cycle
E21
has been interrupted
because there is no
cleaner
The washing cycle
E22
has been interrupted
because there is no
sanitizing cleaner
The washing cycle has
E23
been interrupted during
the fi nal sanitization
stage
Automatic cleaning
E24
system failure
E26
System fi lling procedure
E25
not completed
Remedy
Contact an authorized service agent
The oven solves the problem on its own
Call an authorized service agent
Call an authorized service agent
Call an authorized service agent
Check the pipe position and the level of
cleaner in the tank; top up if necessary and
restart the washing cycle.
If it is not possible to complete the cleaning
operation, perform an emergency rinse or
rinse the cooking chamber by hand
Check the pipe position and the level of
sanitizing cleaner in the tank; top up if
necessary and restart the washing cycle.
If it is not possible to complete the cleaning
operation, perform an emergency rinse or
rinse the cooking chamber by hand
Press the reset button and rinse the cooking
chamber thoroughly by hand.
Operate the oven in convection mode to dry
the cooking chamber.
Check that no residues of cleaning products
have been left inside the cooking chamber.
Rinse the cooking chamber by hand.
Check the position of the pipe and the level
of the sanitizer in the container; if necessary,
top it up and re-launch the automatic
cleaning cycle.
Combination Oven Installation and Operation Manual
Section 8
Troubleshooting
Notes
The oven's functions are
disabled so no cooking
cycles can be carried out
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions
are disabled; no cooking
cycles can be performed
If the problem persists,
call an authorized service
agent
If the problem persists,
call an authorized service
agent
If the problem persists,
call an authorized service
agent
If the problem persists,
call an authorized service
agent
The oven's functions
are enabled so cooking
cycles can be performed
If the problem persists,
call an authorized service
agent
89