Miller Filtair 550H Manuel D'utilisation page 19

E. Attaching Top Cover Support Brackets, Top Cover Mounting Brackets, And Top Covers
4
4
2
OM-254 498 Page 15
2
1
Installing Foam Tape
1
.
See Section 4-1 for installation
hardware torque values.
1 Long Support Bracket
2 Side Support Bracket
3 Center Support Bracket
4 Button-Head Screw
Use sixteen 1/4 x 3/4 in. screws and
nuts to attach two side support
brackets and one center support
bracket to each long support brack-
et as shown.
Use eight button-head 1/4 in.
screws, four regular-head 1/4 x 3/4
in. screws, and twelve nuts to
3
attach long and side support
brackets between perimeter ends
and extractor sides.
5 Foam Tape
Measure and cut proper length of
foam tape to fit across the top of the
long and side support brackets.
Peel off backing from tape and ap-
ply tape to support brackets.
Install long and short support
mounting brackets beneath
perimeter bracket, and also
beneath extractor.
5
300 965-3/ Ref. 300 963-2A