Table des Matières
Publicité
C. Assembling Extractor Housing
2
1
1
4
D. Attaching Extractor Housing And Left Side Perimeter Bracket
3
5
3
6
5
7
1
4
5
Install square
mounting bracket
beneath perimet-
er bracket.
1
6
4
2
3
1
4
2
300 965-4
.
See Section 4-1 for installation hard-
ware torque values.
1
Extractor Side Bracket
2
Extractor Top Cover
3
Angle Flange Adapter Duct
4
Extractor Tray
5
Tray Side Mounting Bracket
6
Extractor Mounting Bracket
7
Tray Mounting Bracket
Use ten 1/4 x 3/4 in. screws and nuts to
attach two left extractor side brackets to
two right extractor side brackets.
Use twelve 1/4 x 3/4 in. screws and nuts
to attach two extractor mounting brackets
to extractor side brackets.
Use eight 1/4 x 3/4 in. screws and nuts to
attach two tray side mounting brackets to
extractor side brackets.
Use twelve 1/4 x 3/4 in. screws and nuts
to attach tray mounting bracket to two ex-
tractor trays.
Use eight 1/4 x 3/4 in. screws and nuts to
attach two tray side mounting brackets to
two extractor trays.
Use eight 5/16 x 3/4 in. screws to attach
extractor side brackets to extractor trays.
Use twelve 3/8 in. screws, washers, and
nuts to attach two angle flange adapter
ducts to two extractor top bracket.
Use twelve 1/4 x 3/4 in. screws and nuts
to attach two extractor top brackets to
extractor side brackets.
300 965-5
.
See Section 4-1 for installation hard-
ware torque values.
1
Extractor Housing
2
Right Side Perimeter Bracket
Use eight 5/16 x 3/4 in. screws and nuts
to attach extractor housing to right side
perimeter bracket.
3
Left Side Perimeter Bracket
4
End Perimeter Bracket
5
Corner
Use eight 5/16 x 3/4 in. screws and nuts
to attach extractor housing to left side
perimeter bracket.
Use ten 1/4 x 3/4 in. screws and nuts to
attach two corners to front and rear peri-
meter brackets.
6
Square Mounting Bracket
.
Before installing square mounting
bracket, be sure perimeter is square
by measuring the distance between
diagonally opposite corners. The
perimeter is square if the two meas-
ured distances are equal.
Use eight 1/4 in. button-head low-profile
screws and nuts to attach a square
mounting bracket at each corner of the
perimeter assembly.
OM-254 498 Page 14
Publicité
Table des Matières
