Table des Matières
Publicité
4-3. Automation Hood Assembly
.
See Section 6 for an exploded parts view.
A. Tools Needed
B. Attaching Components To Perimeter Brackets
3
4
7
7
.
See Section 4-1 for installation hard-
ware torque values.
1
Upper Perimeter Bracket Mounting
Plate
2
Lower Perimeter Bracket Mounting
Plate
3
Side Perimeter Bracket A
4
Side Perimeter Bracket B
Use sixteen 1/4 x 3/4 in. screws and nuts
to attach upper and lower perimeter brack-
OM-254 498 Page 13
3/8, 7/16, 1/2, 9/16 in.
Insert rubber bumpers
beneath perimeter brackets
8
5
6
et mounting plates to side perimeter brack-
et A and side perimeter bracket B.
5
Corner
6
Lifting Bracket
Use twenty 1/4 x 3/4 in. screws and nuts to
attach four corners to both the left and right
side perimeter brackets.
Use sixteen 5/16 x 1 in. screws and nuts to
attach four lifting brackets to the corners.
7
End Perimeter Bracket
3/8, 7/16, 1/2, 9/16 in.
1
2
3
8
Perimeter Bracket Mounting Plate
Use twenty 1/4 x 3/4 in. screws and nuts to
attach perimeter bracket mounting plates
to end perimeter brackets.
Use twenty 1/4 x 3/4 in. screws and nuts to
attach end perimeter brackets to two
corners on side perimeter brackets.
9
Rubber Bumper
Insert ten (250M models) or twelve (350S
models) rubber bumpers into bottom of
perimeter brackets.
5/32 in. Allen Head
9
7
7
4
300 965-1 / Ref. 300965-9
Publicité
Table des Matières
