Delivery And Handling; Transportation; Storage; Identification - Grundfos SL1 Notice D'installation Et De Fonctionnement

4. Delivery and handling

The pump may be transported and stored in a vertical or
horizontal position. Make sure that it cannot roll or fall over.

4.1 Transportation

All lifting equipment must be rated for the purpose and checked
for damage before any attempts to lift the pump. The lifting
equipment rating must under no circumstances be exceeded.
The pump weight is stated on the pump nameplate.
Warning
Always lift the pump by its lifting bracket or by
means of a fork-lift truck if the pump is fixed on a
pallet. Never lift the pump by means of the motor
cable or the hose/pipe.

4.2 Storage

During long periods of storage, the pump must be protected
against moisture and heat.
Storage temperature: -22 °F to +140 °F (-30 °C to +60 °C)
Warning
If the pumps are stored for more than one year or
it takes a long time before it is put into operation
after the installation, the impeller must be turned
at least once a month.
If the pump has been in use, the oil should be changed before
storage.
After a long period of storage, the pump should be inspected
before it is put into operation. Make sure that the impeller can
rotate freely. Pay special attention to the condition of the shaft
seal, O-rings, oil and the cable entry.

5. Identification

5.1 Nameplate

The nameplate states the operating data and approvals applying
to the pump. The nameplate is fitted to the side of the stator
housing close to the cable entry.
Fix the extra nameplate supplied with the pump to the cable end
in the controller.
1
2
3
4
9901063000000001
5
6
7
8
9
10
11
12
13
14
Fig. 3 Nameplate
Pos. Description
1 FM marking
2 Thermally protected
3 Type designation
4 Serial number
5 Production code (year/week)
6 Maximum ambient temperature
7 Maximum head
8 Maximum flow rate
9 Rated input/output power
10 Rated voltage, D
11 Rated voltage, Y
12 Frequency
13 Country of production
14 CSA mark
15 FM mark
16 Enclosure class to IEC
17 Maximum installation depth
18 Power factor
19 Number of phases
20 Rated speed
21 Service factor
22 Full load current, D
23 Full load current, Y
24 Insulation class
25 Weight without cable
15
16
R
17
18
19
20
21
22
23
24
25
7