Caster/Forks Assembly (Fig.4.3); Dual-Post Armrests (Fig.4.4 - 4.5); Height Adjustment; Height-Adjustable Armrests (Optional) - Quickie SR 45 Notice D'utilisation

CASTER/fORKS ASSEMbLY (fIG.4.3)

Installation
• Remove dust cover (A) from caster housing. Pry cover
off using a back and forth motion.
•
Caster assembly holds one nut (B) and one washer
(immediately below the nut). Remove nut and
washer.
•
Insert caster stem (C) into caster housing (D) and
place washer on stem.
•
Replace nut (B) on caster stem and tighten until all
play is removed; then loosen approximately 1/8 turn,
allowing for free rotation.
•
Replace dust cover to caster housing.

height Adjustment

•
Loosen and remove bolt (E).
•
Set axle at desired height using pre-set holes in the
fork.
•
Replace and tighten bolt.
•
Repeat on other side.
NOTE: The frame must be kept horizontal when height is
adjusted. Refer to page 26 for rear axle height
adjustment.

DuAL-PoSt ARMReStS (fIG.4.4 - 4.5)

Installation and Removal
•
The assembly is held securely in place when the
securing lever (F) is facing rearward.
• Push front securing lever (F) down to release, or lift
transfer bar lever (G), whichever is present.
•
Completely press lever (H) inward on rear post.
•
Lift armrest out of receivers.
height-Adjustment
•
Release the upper securing lever (I).
•
Set armrest at desired height.
•
Return securing lever to locked position.
•
Move armrest up or down to allow armrest to snap
into place.
flip back (optional)
•
Release the front securing lever (F) or lift up transfer
bar lever (G), whichever is present.
•
Flip the armrest back, it remains attached to the rear
receiver.
•
To detach armrest completely press lever (H) inward
on rear post and lift up.
•
To reattach, move armrest down into place.
•
Return securing lever (F) to locked position (if
applicable).
Fig.4.3
A
B
c
D
SR45 Rev.1.0

hEIGhT-ADJUSTAbLE ARMRESTS (OPTIONAL)

(Fig.4.6)
Installation
•
Slide the outer armpost into the receiver mounted to the
wheelchair frame.
•
The armrest will automatically lock into place.
height Adjustment
•
Rotate release lever to second stop.
•
Slide armrest pad up or down to desired height.
•
Return lever to locked position against armpost.
• Push arm pad until upper armpost locks firmly into place.
Removing Armrest
•
Rotate release lever to first stop and remove the armrest.
Replacing Armrest
•
Slide armrest back into receiver.
•
Return release lever to locked position against armpost.
Adjusting Armrest Receiver fit
To tighten or loosen the fit of the outer armpost in the
receiver:
•
Loosen the bolts on the sides of the receiver (9).
•
With the armrest in the receiver, squeeze the receiver to
achieve the desired fit.
•
Tighten the four bolts.
Fig.4.6
1. Outer arm post
2. height-Release Lever
3. Release lever
4. Arm rest pad
5. Transfer bar
6. Side panel
e
7. Receiver
8. Clamp
9. Receiver adjuster bolts
Fig.4.4
f
Fig.4.5
G
4
6
2
3
1
7
I
h
I
h
5
8
9
21