Cardin Elettronica SL Série Mode D'emploi page 65

5p) Remote memorise
• Press PROG/OK to scroll between the available choices:
- ON - OFF
• Press the arrow button
move to the next parameter.
Memorising other S4XX - S500 channels via radio, see chapter
5q) CP gate open
• Press PROG/OK to scroll between the available choices:
- RES. PAUSE TIME (resets the pause time)
- STOP (blocks the pause time count)
• Press the arrow button
and move to the next parameter.
This option determines the behaviour of the programmer if the safety edge CP is activated when the sliding gate is
completely open by either resetting the pause time or blocking it. In the last case you will need to impart a new movement
command in order to continue the count or activate a closing manoeuvre.
5r) LC/CH2 output
• Press PROG/OK to scroll between the available choices:
- RADIO CHANNEL (the contact is commanded by the second radio channel)
- COURTESY LIGHT (the contact is timer controlled)
- ERROR SIGNAL (the contact closes if an error is detected
• Press the arrow button
the choice and move to the next parameter.
This option determines the behaviour of the LC/CH2 output at binding posts 9-10, see chapter
to confirm the choice eg. ON. The programmer will save the choice and
REMOTE CONTROL
to confirm the choice eg. STOP. The programmer will save the choice
to confirm the choice eg. RADIO CHANNEL. The programmer will save
.
only series
FUNCTION MODES
65
5p) Remote memorise
INSTALLED MOTOR
LEFT
MANUAL MODE
ON
REMOTE MEMORISE
ON
5q) CP gate open
MANUAL MODE
ON
MEMORADIO
ON
CP GATE OPEN
STOP
5r) LC/CH2 output
MEMORADIO
ON
CP GATE OPEN
STOP
LC/CH2 OUTPUT
RADIO CHANNEL