Programming Procedure; Start Up Screen - Cardin Elettronica SL Série Mode D'emploi

Programming procedure

1) START UP SCREEN

• Run the mains power supply to the programmer and connect it to the separate terminal board:
• Connect the control and security device wires.
ATTENTION: ALL UNUSED N.C. CONTACTS MUST BE SHORT CIRCUITED
• The digital display will show the start up screen with the indication 'PROGRAM' flashing
Indications on the display
- Indicator for the blocking button
- Indicator for the inverting photoelectric cells
- Indicator for the stop photoelectric cells
- Indicator for the safety edge
- Indicator for the opening button
- Indicator for the closing button
- Indicator for the sequential command
- Indicator for the limited opening button
If the security device has not been activated (white characters on a black background) the indications on the
display are at rest. Make sure that when the security device is activated the status is inverted (black characters
on a white background).
If one or more of the safety indications
contacts have been bridged.
The indications
TA - TC - TD
pressing the button 'TA' will change the status from 'at rest' to 'active' (white characters on a black background).
symbol on the start-up screen indicates that the ECU is working off mains power.
• The
at rest activated
TB TB
FI FI
FS FS
CP CP
TA TA
TC TC
TD TD
TAL TAL
- - -
TB FI FS CP
change status on the display when the relative command is activated, e.g.
- TAL
24 25 26
22 23
are active, check that the unused safety device
52
1) Start up screen
TB
FS
00.000.007
07-06-16
27 28
1a) Start up screen
(mains power)
TB
FS
00.000.007
07-06-16
PROGRAM
FI TA FD
CP TC TAL
15.35
PROG/OK
PROGRAM
FI TA FD
CP TC TAL
15.35
PROG/OK