Cardin Elettronica SL Série Mode D'emploi page 59

4h) Braking speed
• Press PROG/OK to scroll between the available choices:
- Setting 1 = low speed; Setting 2 = medium speed; Setting 3 = high speed
• Press the arrow button
choice and move to the next parameter.
Setting the braking speed during closing. The default parameter is '1' but it only tales effect if parameter 4g
'braking room' is set to 1, 2 or 3.
4i) Pause time
• Press PROG/OK to enter the sub menu.
• To adjust the pause time press the arrows until the desired time appears on the display:
- to reduce the time;
- to increase the time.
• If you hold the arrow down the value will scroll rapidly and the display will show the changes in real time.
• Press PROG/OK to confirm the chosen value.
• Press to move to the next parameter.
The pause time will be acquired during programming (see paragraph work time programming). This field will
allow you to change the pause time setting without repeating the entire work time programming procedure.
to confirm the choice eg. Setting 3. The programmer will save the
59
4h) Braking speed
GATE DELAY
3 STEPS
BRAKING ROOM
SETTING 2
BRAKING SPEED
SETTING 3
4i) Pause time
DIST. FROM CLOSE
4 STEPS
DIST. FROM OPEN
5 STEPS
PA U S E T I M E
240 SEC.
* * * * * * * * * * * * * * * *
* *
PAUSE TIME
* *
240 SEC.
* *
* * * * * * * * * * * * * * * *