Cardin Elettronica SL Série Mode D'emploi page 63

5g) Test FI
• Press PROG/OK to scroll between the available choices:
- ON - OFF
• Press the arrow button
move to the next parameter.
If you enable the security test you will have to connect both the transmitter and the receiver to the controlled load output
(CTRL 24 Vdc binding posts 14-15). When the test is enabled one second will pass between receiving a command and
carrying it out.
5h) Test FS
• Press PROG/OK to scroll between the available choices:
- ON - OFF
• Press the arrow button
move to the next parameter.
If you enable the security test you will have to connect both the transmitter and the receiver to the controlled load output
(CTRL 24 Vdc binding posts 14-15). When the test is enabled one second will pass between receiving a command and
carrying it out.
5i) Installed motor
• Press PROG/OK to scroll between the available choices:
- LEFT (default setting)
- RIGHT
• Press the arrow button
and move to the next parameter.
Sliding gate motors can either be installed to the right or to the left of the passageway.
to confirm the choice eg. ON. The programmer will save the choice and
to confirm the choice eg. ON. The programmer will save the choice and
to confirm the choice eg. LEFT. The programmer will save the choice
63
5g) Test FI
INDICATOR LIGHT
FLASHING
PHOTOCELL INVERT
DURING CLOSING
TEST FI
ON
5h) Test FS
PHOTOCELL INVERT
DURING CLOSING
TEST FI
ON
TEST FS
ON
5i) Installed motor
TEST FI
ON
TEST FS
ON
INSTALLED MOTOR
LEFT