Cardin Elettronica SL Série Mode D'emploi page 64

5m) Deadman's switch
• Press PROG/OK to scroll between the available choices:
- ON - OFF
• Press the arrow button
move to the next parameter.
This can be used to move the gate in the closing or opening direction under the direct control of the operator, see
chapter
FUNCTION MODES
5n) Opening direction gate delay
• Press PROG/OK to scroll between the available choices:
- ON - OFF
• Press the arrow button
move to the next parameter.
If you enable gate delay the following will occur: during the opening movement gate leaf 1 moves first and then gate
leaf 2. In the closing direction gate leaf 2 moves first then gate leaf 1. If gate delay is disabled both gate leaves move
simultaneously.
5o) Electric lock
• Press PROG/OK to scroll between the available choices:
- ON - OFF
• Press the arrow button
move to the next parameter.
If the electric lock is enabled the ELS output (binding post 8) will be activated before gate leaf 1 moves and will remain
active until gate leaf 1 has moved a few centimetres.
to confirm the choice eg. ON. The programmer will save the choice and
.
to confirm the choice eg. ON. The programmer will save the choice and
to confirm the choice eg. ON. The programmer will save the choice and
64
5m) Dead man mode
TEST FS
ON
INSTALLED MOTOR
LEFT
DEADMAN'S SWITCH
ON
5n) Gate delay
TEST FI
ON
TEST FS
ON
GATE DELAY
ON
5o) Electric lock
TEST FS
ON
GATE DELAY
ON
ELECTRIC LOCK
ON