Setup Requirements - Angelcare AC017 Manuel De L'utilisateur

11.7 Reverse polarity installation of the batteries in the end product must
be avoided. Reverse insertion of batteries can cause charging, and that
may result in leakage or explosion.
11.8 Remove the battery from this product if you store the product over 30
days because the battery could leak and damage the product.
11.9 Discard 'dead' batteries as soon as possible since 'dead' batteries are
more likely to leak in a product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
11.10 DO NOT store this product, or the battery provided with or identified
for use with this product, in high-temperature areas.
WARNING
(North America Only)
12. Modifications not authorized by the manufacturer may void users
authority to operate this device.
12.1 NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
12.2 However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment OFF and ON, the user is encouraged to try
to correct the interference by one or more of the following measures:

SETUP REQUIREMENTS

INCLUDED:
Nursery Unit
WHAT YOU WILL NEED (NOT INCLUDED):
Tabletop stand
(for Nursery Unit)
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
12.3 This device complies with the part 15 of the FCC Rules and the
Industry Canada license - exempt RSS standards(s). Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
IC Warning :
13. This device complies with industr y C anada RSS standard(s).
O p e r a t i o n i s s u b j e c t t o
( 1 ) t h i s d e v i c e m a y
(2) this device must accept any interference, including inferences that
may cause undesired operation of the device.
13.1 Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Model AC017
Movement Monitor
Wireless movement
Sensor Pad
* Always place Angelcare
logo side up *
Miniature Philips
Screwdriver
t h e f o l l o w i n g t w o c o n d i t i o n s :
n o t c a u s e i n t e r f e r e n c e ,
CR3032 battery
(for Sensor Pad)
2X
2 AAA Alkaline
Batteries
E
N
a n d
3