2.2 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
If your crib does not have a solid, stable surface for the Sensor Pad, you will
need to place a support under it, to ensure correct operation of the system.
This hardboard support should be at least 1/4'' (6 mm) thick and should have
minimum dimensions of 13'' x 13'' (33 x 33 cm). This support board must be
larger than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except memory-
foam mattresses, hollow frame mattresses and water beds. The hardboard
maintains a constant pressure on the Sensor Pad, enabling it to detect the
baby's movements even when the baby is at the edges of the crib.
Sensor Pad
WARNING
• The Sensor Pad is not designed for use with adults, children or infants older
than 24 months.
• Discontinue used of the Sensor Pad when child is older than 24 months.
Remove Sensor Pad from crib and store for future use.
• BEFORE FIRST TIME USE: To test that the unit is ready for use, refer to instruction
manual on how to test that the installation has been done correctly.
STEP 3 - TURNING ON YOUR MONITOR
Press and hold the Nursery
Unit ON/OFF button for
2 seconds until the
Nursery Unit Indicator
flashes slowly in green.
1) Remove the battery cover using a coin.
Turn in the direction of the arrow.
2) Place the included battery (CR3032) in
the compartment. Note: The + symbol
should be facing up.
3) Replace the battery cover (the two
dots will line up). The Sensor Pad is
now ON.
1) Remove the mattress from the crib.
2
2) Place the Sensor Pad - Angelcare
side up - in the center of the mattress.
It should be centered on the hardboard
if your crib requires a hardboard
support.
3) Replace the mattress.
The Nursery Unit will emit a
sound and flash blue to
confirm pairing with the
Sensor Pad
NOTE:
If the green light does not appear but
the red light is flashing; or if there
are false alarms, adjust the sensitivity
level (Step 4.3).
E
N
Hardboard
logo
®
5