Before First Use - Unold 58746 Notice D'utilisation

4. When using solid deep-fat frying grease, cut it into cubes and carefully
melt it in a pot on the stove. Then carefully pour the melted grease into
the grease container of the deep-fat fryer and ensure the proper fill level
(between the MIN and MAX marks). After the appliance has cooled, this
grease will solidify and must first be melted in a pot as previously described
before reuse.
5. Do not overheat the grease, otherwise the surface of the deep-fried food will
become crusted and the inside will not be cooked.
6. The food to be deep-fried must be immersed in the grease, consequently do
not add too much food at the same time. If the quantity of food is excessive,
the grease cools excessively and the food to be deep-fried becomes saturated
with oil.
7. Replace deep-fat frying grease on a regular basis. Deep-fat frying grease that
is past its prime impairs the good flavour of the deep-fried food. Dispose of
oil or grease that is past its prime in an environmentally-responsible manner
in accordance with the local disposal regulations.
8. If you reuse the deep-fat frying grease, first let it cool down slightly and
then before it solidifies, pour it into another container through a sieve lined
with a paper towel or filter paper. Then you can store the grease in a closed
container in the refrigerator. Unfiltered grease spoils quickly.

BEFORE FIRST USE

1. Take all parts such as lid, basket, handle etc. out of the packaging. Remove
all packaging materials. Keep packaging materials away from children–
danger of suffocation!
2. Clean lid, inner pan, basket, handle and housing with warm soapy water and
dry all parts carefully.
3. Place the housing on a flat and solid dry surface.
4. Insert the oil pan until it lies on the top edge of the housing.
5. Insert the heating element and the accessories. Slide the control and heating
element firmly into the recess at the rear side of the housing. The element
must engaged firmly.
6. Tilt the handle of the frying basket outwards until it clicks into place.
7. Put the plug into a receptacle as per rating label.
8. REMARK: The appliance can only be switched on, if the control element has
correctly been inserted.
Copyright UNOLD AG | www.unold.de
29