Overheat Protection/Safety Shut Off; Cleaning And Maintenance - Unold 58746 Notice D'utilisation

OVERHEAT PROTECTION/SAFETY SHUT OFF

1. The appliance is equipped with an
overheat protection. If the appliance
is switched on inadvertently or
without oil in the oil pan and the
heating element is not sufficiently
covered with fat, the appliance is
switched off automatically to avoid
overheating.
2. In this case first switch off and
unplug the appliance. Let the deep
fryer cool off. Remove the heating element and push the small RESTART
button in the cable storage.

CLEANING AND MAINTENANCE

1. Take off the control element by pulling it carefully upwards.
2. The heating and control element must not be plunged into water or any
other liquid or come into contact with water.
3. Take out the oil pan with both hands. If you want to use the oil again pass
it through a very fine sieve. You may store the fat in the enamelled oil pan
with closed lid in the refrigerator. For reuse, solid oil can be heated on the
stove until it's just liquid before placing the heating element.
4. Replace used frying oil regularly. Dispose the used oil according to your
local regulations.
5. Do not use any sharp or abrasive cleaning agents for cleaning of the
enamelled oil pan, as this may scratch the surface. All parts except the
heating and control element can be cleaned in warm soapy water or in the
dishwasher. In case of encrustations, soak the respective parts in warm
soapy water.
6. Wipe the control element with a dry cloth.
7. Dry all parts carefully.
8. Clean the appliance regularly for a longer lifetime of the deep fryer.
9. Reassemble the appliance as described in the chapter „First use".
Unplug before cleaning.
Let the appliance cool off completely. Do not touch the heating
element, as this is still hot for a long time after use.
Copyright UNOLD AG | www.unold.de
31