Mounting The Rudder Horns To The Ailerons; Mounting The Aileron Linkage; Mounting The Receiver And Wings - Reely SKY 20 89 95 Mode D'emploi

l) Mounting the Rudder Horns to the Ailerons
Sketch the installation site of the rudder horn at the ailerons measured in a straight line from the servo rudder horn.
Use, e.g. a matching drill or cutter knife to cut the corresponding holes.
The rudder horns can now be installed at the ailerons with 5-minute epoxy resin (or super glue). As for installation of
the rudder horn for the rudder and elevator, observe that the linkage point is right above the rotating point (also see
schematic illustration of the rudder linkage in figure 2, item 2).
m) Mounting the Aileron Linkage
Create the matching linkage rods with the rods from the construction kit and connect them to the servo rudder horns
(figure 9, item 3).
Shorten the rods so that the ailerons are in the neutral positions when the servo rudder horns are at a precise 90°
angle to the servo housing.
n) Mounting the Receiver and Wings
The precise procedure for installation of the receiver
depends on its build (e.g. 2.4GHz) and construction
size.
Keep sufficient distance from the flight controller and
live cables in any case.
Figure 10, item 1 shows a possible installation site for
the receiver.
The wings are attached to the fuselage with the wing
plugging tube (2).
The servo cables of the ailerons (3) are inserted into
the fuselage on the side and connected to the recipient.
The wing halves are secured against coming loose with
Figure 10
two M6 plastic screws (4) each.
Figure 10, item 5 shows another possible installation
site for the flight battery.
37