Table des Matières
Publicité
4.2.2 Preselection for Permanent Unit Deactivation
Pressing the
key takes you from the "Results 1" screen to the permanent unit deactivation screen.
The
and
keys can be used to select the unit, the status of which should be changed. An arrow below the units
indicates the unit that is selected.
The
key is to be used to change the status of the unit.
A unit is preselected for permanent deactivation if it is shown as follows .
All units which are shown with this symbol
remain unaffected by the permanent deactivation.
The preselection for permanent deactivation can be reversed again for all units by using the key
.
!
Caution: If the status of one of the units is changed, all preselected units are deactivated.
The permanent deactivation is reversed again by pressing the
key in the work screen.
Depending on the configuration of the "Headland -perm.TB" parameter in the machine data (see Table 4-7 page 28-29), the permanent
deactivation is also reversed at the end of the field.
The preselection persists in both cases and can be activated again at any time by using the
key in the work screen.
Figure 4-6 Preselection for permanent unit deactivation
23
Publicité
Table des Matières
