Installation Of The Linear Remote Sensor Type 8798 - Burkert 8798 Manuel D'utilisation

8.2 Installation of the linear Remote
Sensor Type 8798
8.2.1 Attachment to process valves with
internal air supply (series 2103,
2300 and 2301)
NOTE!
When mounting on process valves with a welded body, follow
the installation instructions in the operating instructions for
the process valve.
Procedure:
1. Install switch spindle
Transparent cap
Pilot air ports
(plug-in hose connectors with
collets or threaded bushings)
Actuator
Fig. 8: Installation of linear Remote Sensor, series 2103, 2300
and 2301
14
english
Type 8798
Installation
→
Unscrew the transparent cap on the actuator and unscrew the
position display (yellow cap) on the spindle extension (if present).
→
For version with plug-in hose connector, remove the collets
(white nozzles) from both pilot air ports (if present).
Fig. 9: Installation of the switch spindle, series 2103, 2300 and
2301
NOTE!
Improper installation may damage the groove ring in the
guide element.
The groove ring is already be pre-assembled in the guide element
and must be "locked into position" in the undercut.
▶ When installing the switch spindle, do not damage the groove ring.
→
Push the switch spindle through the guide element.
Puck
Switch spindle
Guide element
Groove ring
max. 1 Nm
max. 5 Nm
Actuator cover
O-ring
Spindle extension