Burkert 8798 Manuel D'utilisation page 23

8.3.2 Attachment to a proportional valve
with swivel actuator
The shaft of the rotating Remote Sensor is directly coupled to the shaft
of the swivel actuator.
Mounting kit on swivel actuator (order no. 787338, can be pur-
chased as an accessory from Bürkert):
Part no. Quantity Name
1 1 Adapter
2 2 Setscrew DIN 913 M4 x 10
3 4 Cheese-head screw DIN 933 M6 x 12
4 4 Circlip B6
5 2 Hexagon nut DIN 985 M4
Tab. 3: Mounting kit to swivel actuator for rotating Remote Sensor
Other accessories:
The assembly bridge with fastening screws (in accordance with
VDI/VDE 3845) can be purchased from Bürkert, quoting order no.
770294.
Procedure:
→
Perform basic installation
(for a description, refer to chapter "8.3.1").
Type 8798
Installation
Adapter
Fig. 22: Fitting the adaptor
→
Fit adaptor to the shaft of the rotating Remote Sensor and attach
with 2 setscrews (see "Fig. 22" ).
Anti-twist safeguard:
Note the flat side of the shaft.
As an anti-twist safeguard, one of the setscrews shall rest
on the flat side of the shaft.
→
Tighten the setscrews with the lock nuts.
→
Assemble the multi-part assembly bridge suitable for the
actuator.
→
Screw the support plate of the rotating Remote Sensor on the
assembly bridge, using 4 cheese-head screws and circlips.
(Refer to "Fig. 23").
english
Setscrews, tightened with
lock nut
23