Electrical Installation - Burkert 8798 Manuel D'utilisation

Caution: (Exhaust air concept):
In compliance with degree of protection IP67, an exhaust
air line must be installed in the dry area (control function A
and B).
Keep the adjacent supply pressure always at least
0.5 – 1 bar above the pressure which is required to move
the actuator to its end position. This ensures that the control
behavior is not extremely negatively affected in the upper
stroke range on account of too little pressure difference.
During operation keep the fluctuations of the pressure supply
as low as possible (max. ±10 %). If fluctuations are greater,
the control parameters measured with the X.TUNE function
are not optimum.
32
english
Type 8798
Electricalinstallation
10 ELECTRICAL INSTALLATION
10.1 Safety instructions
DANGER!
Risk of electric shock.
▶ Before working on equipment or device, switch off the power
supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations
for electrical equipment.
WARNING!
Risk of injury from improper installation.
▶ Installation may be carried out by authorized technicians only
and with the appropriate tools.
Risk of injury from unintentional activation of the system and
an uncontrolled restart.
▶ Secure system from unintentional activation.
▶ Following installation, ensure a controlled restart.