Installation Distances - ST Quadrat LUX-top FSE 2003 Instructions De Montage Et D'utilisation

 The form for installation documentation must be completed after installation and
handed over the building operator/owner and stored together with any non-
permanently installed parts of the equipment in a safe place.
 We recommend that you also additionally document proper installation by taking
photos and with other important installation data. We recommend that you use our
Documentation App for this; download it from
Further information on the assembly documents can be found in DIN EN 795: 2012
*)
(Annex A).
 The installation documents verify to the user that the installation has been carried out
properly and provide the basis for subsequent inspections of the anchor device. A copy
should therefore be kept in the building.
 You must comply with the relevant national regulations and the accident prevention
regulations of the respective country during installation of the anchor device.
 The installers must take measures so that neither components of the anchor device
nor tools can fall from the work area.
 In case of sloped surfaces and roofs, snow guards must be installed to prevent loading
®
of the LUX-top FSE 2003

Installation distances

The distance up to the edge of the building should be selected according to national
regulations and depending on the geometry of the roof.
The correct selection and arrangement of anchor devices for permanent installation of the
surface of the roof must be made depending on the type and use of the anchor device,
taking into account the particular characteristics of the roof's surface.
For information on the recommended design and positioning of the anchor devices on the
roof, please refer to, e.g. the DGUVI 201-056 "Planning principles of anchor devices on
roofs", which were determined within the framework of the international expert working
group D-A-CH-S.
The brochures can be found at
downloaded free of charge.
National provisions
If these proposals deviate from national law, the user assumes full legal risk to the extent
of the deviation.
*)
When using the system in Germany, the information provided in the
must be observed.
ST QUADRAT Fall Protection S.A.
system with snow loads!
:
*)
www.lux-top-absturzsicherungen.de
shall remain unaffected
–
Your competent partner for fall protection
Page 7 Version 04/2017
*)
www.quick-doku.eu
.
by these
national technical approval
–
www.lux-top-absturzsicherungen.de
and can be
recommendations.
Z-14.9-789