Installation Notes - ST Quadrat LUX-top SDH-S Manuel D'utilisation

Installation notes:

®
 LUX-top SDH
The
manufacturer, and in accordance with the separately supplied installation instructions!
IF THE REQUIRED MINIMUM ENGANGEMENT LENGTH IS NOT ENSURED DUE TO THE ROOF
CONSTRUCTION FOUND ON SITE, LONGER WOODSCREWS MUST REQUESTED FROM THE
MANUFACTURER!
 The installers must ensure that the surface is suitable for fixing the anchor device.
 You must comply with the relevant national regulations and the accident prevention
regulations during installation of the anchor device.
 The room below the work area is to be kept clear.
 The installers must take measures so that neither components of the anchor device
nor tools can fall from the work area.
 All connections of the construction must be properly and conscientiously installed and
checked according to the manufacturer's requirements.
 The inspection log card and also the form of the installation documentary must be fully
completed following installation and handed over to the building owner or stored in a
protected place together with the parts of the equipment not permanently installed.
 We recommend that you document proper installation, e.g. by taking photos. We
recommend that you use our Documentation App for this, download from
doku.eu .
 The installation documents verify to the user that the installation has been carried out
properly and provide the basis for subsequent inspections of the anchor device.
Combination with other LUX-top products:
®
 The LUX-top SDH
temporary horizontal flexible anchor lines to EN 795 Type C. In doing so the strain of
®
the LUX-top SDH
instructions of the respective temporary system!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection solutions – www.lux-top-absturzsicherungen.de
may only be installed using the fastenings supplied with it by the
product can be used with temporary horizontal anchor devices /
must not exceed 12 kN. In this case, note and follow the user
6
www.quick-
Version 12/2017