Installation Distances - ST Quadrat LUX-top FALZ-PLUS II Manuel D'utilisation

Installation distances:

The distances to the edge are to be selected according to national provisions and
depending on the roof geometry.
Anchor devices that are permanently provided on the roof area should be correctly
selected and arranged depending on the type and use of the anchor device taking the
particular features of the roof area into account.
Please find information about the recommended execution and positioning of anchor
points on the roof e.g. in BGI 5164 / DGUV I 201-056 "Planning principles for anchor
devices on roofs", which was coordinated within the framework of the international group
of experts, D-A-CH-S.
The brochure is
absturzsicherungen.de
National provisions remain unaffected by these recommendations. If these suggestions
differ from national law, the user of this recommendation takes the full legal risk to the
extent of the discrepancy.
Permitted distances between the anchor points on the
Purely as individual anchor points
With temporary horizontal anchor devices
With LUX-top ® FSE
systems
In case of uncertainty, please contact the manufacturer
*Results from the fall over the edge problem relating to the lanyard for horizontal use.
Directly on the edge, any work to the side of the anchor point should be limited to 1.5 m max.!
Combinations with other LUX-top products:
 The product LUX-top
and also as an intermediate point (optionally also with drive-over-resistant rope guide)
®
in LUX-top FSE 2003
+ CEN/TS16415:2013. For this purpose, also observe the instructions for use for the
®
LUX-top FSE 2003
 The product LUX-top
devices / temporary horizontal flexible anchor lines according to DIN EN 795 Type C.
For this purpose, observe the instructions for use for the relevant temporary system!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection devices – www.lux-top-absturzsicherungen.de
available to download
among other places.
2003 stainless steel rope
®
FALZ-PLUS II
stainless steel rope systems according to DIN EN 795 Type C
system!
®
FALZ-PLUS II
Page 5 Version 11/2018
free of charge
®
LUX-top FALZ-PLUS II
Maximum 3.0 m*
Maximum 7.5 m
Bigger distances also possible depending on the
system
Maximum 7.5 m (recommended)
Maximum 15 m (according to test certificate)
can be used as a starting/end or corner point
can be used with temporary horizontal anchor
at www.lux-top-
system