ST Quadrat LUX-top FSE 2003 Instructions De Montage Et D'utilisation page 38

®
(1) LUX-top stainless steel cable 8.0 mm
Design 7x7 - Minimum breaking force 36 kN AISI 316
as permanently remaining guide rope
®
in LUX-top FSE 2003 cable-based fall-arrest system.
®
(2) LUX-top tensioning device
Factory pressed as a tensioning element
®
in LUX-top FSE 2003 lifeline systems.
Also available for self-pressing for trained LUX-top
®
(3) LUX-top end terminal
Factory pressed - as connection
between stainless steel rope and end anchor in
®
LUX-top FSE 2003 lifeline systems.
Also available for self-pressing for trained LUX-top
®
(4) LUX-top SKE II
Serves as a tool for defining the tension of the stainless steel cable
as well as an energy absorber in the event of a falling load
and also protects the system against extraordinary loads due to thermally induced change in length.
®
(5) LUX-top butt connector
For the straight coupling of stainless steel cables
®
in LUX-top FSE 2003 cable-based fall-arrest system.
®
(6) LUX-top corner connector
For coupling two stainless steel cables on the corner point
®
in LUX-top FSE 2003 cable-based fall-arrest system.
®
(7) LUX-top distribution disc
For coupling several stainless steel ropes
®
in LUX-top FSE 2003 cable-based fall-arrest system.
®
(8) LUX-top corner rope protector
As a cable support on the corner points
®
of LUX-top FSE 2003 cable-based fall-arrest system.
Available in the versions 45°, 90°, 115° and 135°.
®
(9) LUX-top rope guide - straight - type SZH-Z
Enables the free traversing of intermediate hold points
®
in LUX-top FSE 2003 stainless steel cable systems
Design: for double-sided use
®
(10) LUX-top rope guide - one-sided - type SZH-E
Enables the free traversing of intermediate hold points
®
in LUX-top FSE 2003 stainless steel cable systems.
Design: for one-sided use
®
(11) LUX-top rope guide - wall- and ceiling assembly - type SZH-W
Enables the free traversing of intermediate hold points in LUX-top
systems.
Design: cropped for wall assembly and ceiling assembly (overhead assembly).
Under certain conditions, assembly without an additional
anchor point directly on the substructure is possible.
PLEASE ASK THE MANUFACTURER!
®
(12) LUX-top rope guide - top - type SZH-O
As rope guide that can be screwed directly onto the side of steel components (overhead assembly).
®
(13) LUX-top rope guide 90°
Enables the free traversing of corner points in
®
LUX-top FSE 2003 stainless steel lifeline systems.
ST QUADRAT Fall Protection S.A.
®
®
.
–
Your competent partner for fall protection
Page 12 Version 04/2017
installers.
installers.
®
FSE 2003 stainless steel lifeline
–
www.lux-top-absturzsicherungen.de