ST Quadrat LUX-top FSE 2003 Instructions De Montage Et D'utilisation page 30

 The stability of the mounting base after a person secured to the
falls, must be checked by a qualified person before re-assembling a new anchor device
on site. If necessary, the complete lifeline system including the anchoring system or
individual components must be replaced.
 On-site operating instructions with information on the location and use of the anchor
devices should be attached at the access to the safety system (e.g. roof hatch)!
 The relevant national regulations and the health & safety regulations (in Germany the
accident prevention regulations of the trade associations responsible for industrial
safety) and any other relevant regulations must be complied with when using the
®
LUX-top FSE 2003
 TRBS 2121 "Technical rules for health & safety at work - risk to people due to falling".
 DIN 4426 "Safety requirements for workplaces and transport routes".
 DIN 363 "Personal fall protection equipment - personal fall protection systems".
 DGUV Regulation 38
 DGUV Regulation 112-198 "Use of personal protective equipment against falls"
 DGUV Information 201-008
 DGUV Regulation 101-016 "Roof Work"
 DGUVI 201-056 "Planning principles of anchor devices on roofs"
 ASR A2.1 "Technical rule for workplaces - Protection against falling and falling objects,
entering dangerous areas"
 Ensure safe and stable position when using the anchor device!
 There must be a rescue plan which takes into consideration all possible emergencies
so that potential rescue operations can be carried out quickly and safely.
 The lanyard must always be set as short as possible, even when fall arrest systems
are used, in order to reduce any free-fall height in case of a fall to a minimum. It is
essential for safety that the position of the anchor device and the plan of work be
chosen so that any free fall and the fall height are limited to a minimum. Ideally, a
fall over the edge should be completely prevented by appropriate use of the
PFPE against falls from a height.
 Position the anchor device on the building so that in case of a fall over the roof edge,
the maximum possible fall factor is 1.
 Please note that failing to follow these user instructions, and if the documentation is
incomplete, all claims for compensation are excluded.
 The manufacturer must be contacted in case of any uncertainty during installation or
use of the system!
ST QUADRAT Fall Protection S.A.
system. For Germany these include, among other things:
"Construction Work"
"Roof Work"
–
Your competent partner for fall protection
Page 4 Version 04/2017
®
LUX-top FSE 2003
–
www.lux-top-absturzsicherungen.de