Instructions For Cart Mounting; Attaching And Removing Tray - natus OLYMPIC SMART SCALE 60 Mode D'emploi

Anchor Holes (4)
Bottom
of Scale
Fig. 1C
Tray Leg
Phillips screw
Tray Mount
Fig. 1D

Instructions for Cart Mounting

Four threaded (10-32 UNF) holes are provided in the base plate of
scale for securing it to any cart or table (Fig. 1C). The rubber feet
may remain in place.
CAUTION: If using the scale on a cart, ensure that the scale
is securely attached to the cart. Only use cart or tables that
are strong and stable enough to safely support the weight
of the scale as well as any objects (e.g., baby).

Attaching and Removing Tray

Any time a tray is changed, the scale must be calibrated and the
zero offset adjusted with the new tray in place (see Calibration on
page 3-1 and Adjusting the Zero Offset on page 3-17).
CAUTION: Ensure that all four tray legs are secure before
placing a baby in the tray.
To remove the tray:
1. Loosen the four Phillips screws that secure the tray legs
(Fig. 1D).
2. Lift the tray straight up (Fig. 1E).
To attach tray:
1. Lower the tray so all four feet fit into the tray mounts.
2. Securely tighten all four Phillips screws (Fig. 1D).
OLYMPIC SMART SCALE
Section 1: Installation
Tray Mounts (4)
Fig. 1E
® Model 60/65
Tray Feet (4)
Page 1-3