Suspending The Lift From The Rail; Hand Control - human care Roomer S 55300H Mode D'emploi

Roomer S
Suspending the lift from the rail
Place the lift on a suitable surface. Turn the
lever (10) so it is pointing towards the leg hook
(5) and pull out (do not jerk it) the lift belt on
the bar side (2) up to the hook on the distance
strap and hook it diagonally from above (see
fig).
Then turn the lever (10) so that it points
2
3
towards the bar (4) and the lift belt (2) is now
connected. Switch on at the mains and the lift is
ready for use.
4
The direction of the lever (10) determines
which belt is engaged and which is active. If the
lever (10) is pointing towards the leg hook (5)
the belt nearest the leg hook (3) is active. If the
lever (10) is pointing towards the bar (4) the
belt nearest the bar (2) is active.
10 5

Hand control

The hand control is equipped with an Up but-
ton (1) and a Down button (2) for raising and
1
lowering the lift.
When the lift is loaded with less than approx. 2
40 kg it can be run at two speeds. If the Up
or Down button is pressed for longer than 3
seconds, the lift will run in the faster mode. If
the lift is loaded with more than approx. 40 kg it
will only run in the slower mode.
On the short side of the hand control there is an
input for charging the lift and an input (USB-C)
for communicating with the lift.
30 www.humancaregroup.com