Correct Procedure For Demounting/Mounting Run Flat Tyres Fitted With Valve Sensor - TECO 100 Variant Manuel D'utilisation

- Restart the rotation to complete the mounting phase.
- Remove clamp, bead pressing tool, lever-less head and bead breaker disc.
8• Set the bead breaking unit to the rest position
9• Tyre inflation
- For inflation, see "INFLATION" section.
10 • Unlock the wheel from the turntable (Standard version and AL version)
Manual turntable (Standard version - fig. 30a)
- Undo the device by turning the handles 1 anti-clockwise.
- Press the retainers 2 and move the centring cone away from the rim by hand.
- Turn the clamping device anti-clockwise to release it from the turntable.
- Remove the device from the rim.
Pneumatic turntable (AL version - fig. 30b)
- Turn selector 16 to unlock the clamping pin (A).
- Press the retainers and move the centring cone away from the rim by hand (B).
- Remove the device from the rim (C).
11 • Tyre unloading (fig. 31)
- Rise the wheel lifter (pedal 29) and position the wheel on it by hand (A).
- Release the pedal 29 to lower the lift (B).
- Remove the wheel from the lifter.
CORRECT PROCEDURE FOR DEmOUNTING/mOUNTING
RUN FLAT TYRES FITTED WITH VALVE SENSOR
NB: if the sensor is on the tyre valve.
• Remove the valve plunger and let all the air out of the tyre.
• NB: If necessary, remove the valve fixing nut and let the sensor to fall into the tyre.
• Place the sensor at 3 o'clock.
• Lower the bead breaker disc and start the rotational bead breaking stage.
• Lubricate the bead and continue rotational upper bead breaking until the sensor is at 12 o'clock
and not beyond.
• Raise the bead breaker disc.
• Move the sensor to 6 o'clock.
• Push in the bead breaker disc and fit the gripper at 2 o'clock.
• Apply plenty of lubricant and break the lower bead.
• Move the gripper to 2 o'clock (sensor at 6 o'clock).
• Position the demounting unit (tool head).
• Lower the swing tool to find the bead.
• Rotate clockwise so that the gripper is at 6 o'clock (sensor at 10 o'clock).
• The bead is now engaged.
• Engage the bead with the demounting head.
• Rotate clockwise to demount the tyre, with the bead breaker disc in the down position.
• Remove the gripper.
• Now demount the tyre underside, taking care not to damage the sensor.
User Manual TECO 100 Variant
Demounting (fig. 32)
45