Appendix 7: Installation And Use Of The Optional Blower And Thermodisc - Enerzone Solution 3.5 Manuel D'installation Et D'utilisation

Report prepared for: Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on 9/6/2018 2:01:07 PM
1 - Installation Manual English (51 of 57)
Appendix 7: Installation and Use of the Optional Blower and
An optional blower can be installed on the back of the stove to increase the flow of air past heat
exchange surfaces and to help circulate warm air in the room. When used regularly, the blower can
provide a small increase in efficiency, up to 2 percent. However, the use of a blower should not be
used as a way to gain more output from a stove that is undersized for the space it is intended to
heat. You can purchase this option through your ENERZONE dealer. Make sure to specify this part
number: # AC01000
When using the optional blower, allow the stove to reach operating temperature (approximately
one hour), before turning it on. The increased airflow from the blower cools the firebox and could
affect the start-up combustion efficiency if the blower is turned on too early. You can also install, on
your appliance, the thermodisc # AC05530 (basic model included with the blower), to enable the
blower to start or stop automatically when the stove is hot or too cold. It is possible to install the
quick connect thermodisc instead # AC02055, sold separately.
Characteristics of the thermodisc:
•
Starts the blower when the stove's temperature reaches 43 °C (110 °F)
•
Cuts the electrical contact when the temperature falls to 32 °C (90 °F).
Solution 3.5 Installation and Operation Manual
Stove Builder International Inc. | 44826 | Rev: Aug 31 2018 3:17PM | Uncontrolled Copy
Thermodisc
CAUTION: ENSURE THAT
BLOWER'S POWER CORD IS NOT IN
CONTACT WITH ANY SURFACE OF THE
STOVE TO PREVENT ELECTRICAL
SHOCK OR FIRE DAMAGE. DO NOT RUN
THE POWER CORD BENEATH THE
STOVE.
THE
51
Page 59 of 201