Parker Service Master CONNECT Manuel D'utilisation page 216

Operation
After selecting the Trigger logic measuring method, the device dis-
plays predefined parameters to complete the measurement.
1 Tap on the
Ä The configuration window opens in which to define the param-
eters.
2 Select a trigger and define the parameters trigger according to
your application.
The table below contains information on the triggers available:
Designation
Keystroke
Level
Window
Time
External
Channel
warning value
Channel alarm
value
Duration
INFORMATION
Please note that the D-IN connection must be activated for the exter-
nal trigger. Refer to Chapter & "D-IN/D-OUT F1/F2" on Page 94.
76
button.
Description
Measurement is started by tapping on the corre-
sponding button
Measurement is started/stopped on exceeding or
dropping below a limit value
Measurement is started/stopped on exceeding or
dropping below one of two limit values for a defined
measuring range
Measurement is started/stopped at a defined mo-
ment of time
Measurement is started/stopped on transition of a
digital signal from High to Low
Measurement is started/stopped on transition of a
digital signal from Low to High
Measurement is started/stopped when defined
warning values occurs
Measurement is started/stopped when defined
alarm values occur
Measurement stops after a defined time period has
expired
The Parker Service Master CONNECT V1.2/06/21 EN