Parker Service Master CONNECT Manuel D'utilisation page 207

6.5.1 Start/Stop
The Start/Stop measuring method starts the recording of the mea-
sured values after tapping on the Start/Stop button.
Recording is stopped by tapping on the Start/Stop button again.
The Start/Stop measuring method implements an automatic data
compression feature and requires no further adjustment.
In addition to the current measured value, the Min and Max values are
also saved.
The measurement is completed independent of the current storage rate
at a scanning rate of 1 ms.
If the predefined memory area is full, the data compression is activated.
The storage rate is doubled and every second measured value is de-
leted. In this case, the Min and Max values are also compared and the
highest and lowest measured value are transferred to the Min and Max
value respectively.
INFORMATION
The Min and Max values are not lost but are saved, even in the case
of long-term measurements.
The Parker Service Master CONNECT V1.2/06/21 EN
Operation
67