Point Measurement - Parker Service Master CONNECT Manuel D'utilisation

Operation
6.5.3

Point Measurement

The Point measurement measuring method starts recording of the
measured values through the triggering of a defined trigger. The record-
ing includes the respective, current measured value of all the active
channels at the time of triggering.
The table below contains information on the triggers available:
Designation
Keystroke
D-IN falling slope
D-IN rising slope
Channel alarm
Channel warning
After selecting the Point measurement measuring method, the device
displays a predefined trigger to start the measurement.
1 Tap on the
Ä The configuration window to select the trigger opens.
2 Select a trigger source according to your application.
70
Description
Recording of a measuring point by tapping
on the corresponding button
Recording of a measuring point on transition
of a digital signal from High to Low
Recording of a measuring point on transition
of a digital signal from Low to High
Recording of a measuring point if defined
alarm values occur
Recording of a measuring point if defined
warning values occur
button.
The Parker Service Master CONNECT V1.2/06/21 EN