Mounting The Device - Parker Service Master CONNECT Manuel D'utilisation

5.5

Mounting the Device

If necessary, you can mount the device on a wall after assembling the
VESA holder (100 mm × 100 mm) on the rear panel of the device.
Fig. 15 Assembling the holder
Mount the device in the following sequence:
1 Assemble the VESA holder at the installation location. Observe
the information in the manual supplied with the VESA holder.
2 Mount the device on the VESA holder.
3 Screw the device using four retaining screws and an appropriate
tool.
Ä The device is mounted.
INFORMATION
The maximum screw-in depth for the retaining screws is 6 mm. The
VESA holder and screws necessary for assembly (M4 metric) are
included in the supply package.
The Parker Service Master CONNECT V1.2/06/21 EN
Starting Up
37