Cloning Radio Using Two Sucs And A Radio-To- Radio Cloning Cable (Optional Accessory) - Motorola Solutions DTR600 Mode D'emploi

3 Exit the 'cloning' mode by long pressing the Home/
Back button.
4 If cloning fails, refer to
on page 48.
When ordering the MUC, refer to P/N# PMPN4465_.
NOTICE:
User should not remove the radios from the
MUC when cloning is on-going.
Cloning Radio Using Two SUCs and a
Radio-to- Radio Cloning Cable
(Optional Accessory)
Before starting the cloning process, ensure that you have
the following hardware:
• A Cloning Cable (P/N# HKKN4028_).
• A fully charged battery in each of the radios.
• Two Single-Unit Chargers (SUC) for radio cloning.
• Ensure that the radios are turned on.
What To Do If Cloning Fails
Figure 5: Radio to Radio Cloning
1 Plug one side of the cloning cable micro-USB
connector to the first SUC and the other end to the
second SUC.
NOTICE:
During the cloning process, no power is being
applied to the SUC. The batteries are not
charged. Only data communication is being
established between the two radios.
2 Turn on the Target Radio and place it into one of the
SUCs.
English
47