What To Do If Cloning Fails - Motorola Solutions DTR600 Mode D'emploi

English
3 For the Source Radio, perform the following actions:
a Press the Menu/OK → Advanced → Cloning →
Radio Cloning
b Place the Source Radio in its SUC.
c Press the Menu/OK button.
The display shows Cloning....
If successful:
• The display shows Cloned Successfully.
If unsuccessful:
• The display shows Cloning Failed.
4 After completing the cloning process, exit the
'cloning' mode by long pressing the Home/Back
button.
48

What To Do If Cloning Fails

In the event that the cloning fails, perform each of the
following steps before attempting to start cloning process
again:
1 Ensure that the batteries on both radios are fully
charged and engaged properly on the radio.
2 Check the cloning cable connection on both SUCs .
3 Ensure that there is no debris in the charging tray or
on the radio contacts and the radio contact is
touching the SUC/MUC contact firmly.
4 Ensure that the Target radio is turned on.
5 Ensure that the Source radio is in cloning mode.
6 Ensure that the two radios are both from the same
frequency band, and same region.