Contact Cloning Failures - Motorola Solutions DTR600 Mode D'emploi

English
If... Then...
Check the charger LEDs indicators
to see if the battery has a problem.

Contact Cloning Failures

This section describes the contact cloning failure scenarios
and ways to troubleshoot.
Cloning scenarios
The slave radio contact list
is full.
The slave radio is powered
down.
The slave radio is out of
range.
If the Private contact or Pri-
vate Group contact ID is
not 11 digit.
The slave radio Profile ID
Number (PIN) is 0000 and
66
Actions
Clean up the contact list
and remove the unwant-
ed contacts.
Ensure the radio in ON.
Ensure the radio is in the
range.
Ensure the contact ID is
11 digit.
Ensure the slave radio
PIN is not 0000 and the
Cloning scenarios
contact to be cloned or de-
leted is within Public Group
1-20.
The slave radio PIN is
locked and the contact to
be cloned or deleted hop-
set is different from the
slave radio.
If All is selected in the Re-
mote Add screen, the slave
radio and Master radio
password does not match.
Slave radio is receiving or
transmitting calls.
Home Group and Group
Only contacts are empty in
the slave radio.
Actions
contact is not within Pub-
lic Group 1-20.
Ensure the radio PIN is
not locked or same hop-
set as the slave radio.
Ensure the PIN matches
Master radio.
Ensure the password
matches or the slave ra-
dio does not have pass-
word.
Perform clone after slave
radio is done with receiv-
ing or transmitting.
Enable legacy DTR Pri-
vate Settings through
Customer Programming
Software (CPS). Radio
stores the Home Group
and Group Only con-
tacts.