Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Control lamp do not illuminate when
the unit is switched on
handpiece when the footpedal is
activated
handpiece when the footpedal is
activated
out pressing the footpedal
64
Switch on the unit with the power switch
Check the connections of the power cable of the unit
Send the unit to an approved Hu-Friedy & EMS repair center
Switch on the unit with the power switch
Check the connections between the power cable and the unit
Check the air connection of the unit
Check the connections between the unit, the handpiece cord and the handpiece
Check the connection of the footpedal
Check the compressed air supply
Clean and dry the powder chamber
Check for presence of powder / air at cord outlet port without handpiece
Check for presence of powder / air at the system connector outlet without cord
Eliminate residual powder present in the handpiece powder channel using cleaning needles
Check the quantity of powder in your unit
Send the handpiece, the cord or the unit to an approved Hu-Friedy & EMS repair center
Switch on the unit with the power switch
Check the connections between the power cable and the unit
Check the water supply of the unit
Check if the water channel of the cord is blocked, blowing through it with compressed air (max 3 bars)
---> If is blocked, send the cord to an approved Hu-Friedy & EMS repair center
Check the connections between the unit, the cord and the handpiece
Check the presence of water at the connector cord output without handpiece
---> If water, the handpiece is blocked and send it to an approved Hu-Friedy & EMS repair center
Check the presence of water at the unit connector cord without the cord
Send the handpiece to an approved Hu-Friedy & EMS repair center
-
Send the unit to an approved Hu-Friedy & EMS repair center
Publicité
Table des Matières
