Star Lab GuardOne Manuel page 35

Setting the LED light preference
1. To switch on/off the LED light, press the LED Light switch (1) to ON/OFF
2. To select an LED light colour, press LED Colour (2).
3. Select the desired colour by pressing the + and - button
can choose between normal white (default) and red.
4. Apply the selection using Save (4).
5. To exit the page, use Back or Home.
Exiting the page without using Save will discard all changes you
have made!
LED Brightness
By pressing LED Brightness, you can adjust the brightness of the LED light
within the GuardOne Workstation.
®
1. Press LED Brightness.
2. Press onto the percentage value (1).
3. Select the desired brightness rate (2) using the + and - button
You can choose from 10 % until 100 % LED brightness in 5 % increments.
The selected LED brightness will be applied to all available LED colours.
4. Apply the selection using Save (3).
5. To exit the page, use Back or Home.
Exiting the page without using Save will discard all changes you have
made!
Screen Brightness
By pressing Screen Brightness, you can adjust the brightness of
the screen of the graphical user interface.
1. Press Screen Brightness.
2. Press the percentage value (1).
3. Select the desired brightness rate (2) using the + and -
button .
You can choose from 10 % to 100% Screen brightness.
4. Apply the selection using Save (3).
5. To exit the page, use Back or Home.
Exiting the page without using Save will discard all changes you
have made!
(3). You
Fig. 40: Setting LED light and colour preference
.
Fig. 41: Adjust the LED Brightness
Fig. 42: Adjust the Screen Brightness
Operation
Operating the Display Area
35
GuardOne ® · Manual ·