Star Lab GuardOne Manuel page 18

Assembly
Installing the PC Side Panels and the Multifunctional Shelf
Installing the PC right sight panel (with cable duct)
Fig. 7: Fix the right side panel to the base plate
Installing the PC shelf to the back panel
Fig. 8: Fix the PC shelf to the back panel
18
· GuardOne · Manual
®
1. Take the PC right side panel (with cable duct, no. 1b) and insert it into
the groove of the base plate. Make sure that the bottom holes in the
PC right side panel are aligned with the holes in the base plate.
2. Make sure that the PC back panel slides fully into the groove of the
aluminium profile on the PC right side panel. Make sure that the holes
in the aluminium profile and the PC back panel are aligned.
3. Use five of the plastic rivets (EVA01) to fix the PC back panel to the
aluminium profile of the right side panel. Push the rivets into the
aligned holes.
4. Use three of the plastic rivets (EVA02) to fix the PC right side panel
to the base plate. Push the rivets into the aligned holes.The right side
panel (with cable duct) is installed.
1. Fix the PC shelf (no. 4) to the PC back panel using the two black screw
assemblies provided.
2. Position the PC shelf at the back panel on the inside of the PC glass
chamber of the GuardOne
NOTICE!
3.
Property damage due to too high rotational torques!
Turn the two black screws into the designated holes on the PC shelf
and the back panel by hand.
If necessary, you can provide additional support to the back
panel with one hand from the outside.
The PC shelf is installed at the back panel on the inside of the glass
chamber of the GuardOne
Workstation.
®
® Workstation.