Adjusting The Airflow - Star Lab GuardOne Manuel

Operation
Operating the Display Area
Fig. 32: Adjust the Airflow
Fig. 33: Operate LED light and colour
28
· GuardOne · Manual
®
Airflow & Light
By pressing Airflow & Light, you can adjust the blower speed or the
LED light at any time during operation.
Precondition:
› You are on the Home page.
1. Press Airflow & Light.

Adjusting the Airflow

2. Press the percentage value (1).
3. Select the desired airflow rate (2) using the + and - buttons
You can choose between 0, 50, 80 and 100 % airflow rate.
Selecting an airflow rate of 0 % will switch off the blower. To switch
it on again, either select an airflow rate above 0 % or use the Quick
Start function on the Home page ("Quick Start and Quick Stop" on
page 27).
The Expiration Hepa Filter field (4) provides information about the
remaining life time of the Hepa filter.
4. Apply the selection using Apply Settings (3).
Your selection is applied immediately.
5. To exit the page, use Back or Home.
Exiting the page without using Apply Settings will discard all changes
you have made!
Operating the LED light
1. To switch on/off the LED light, press the LED Light switch (1).
Your selection is applied immediately.
2. To select an LED light colour, press LED Colour (2).
3. Select the desired colour. You can choose between normal white
(default) and red (3) by pressing the + and - button
Your selection is applied immediately.
4. To exit the page, use Back or Home.
.
.