Star Lab GuardOne Manuel page 34

Operation
Operating the Display Area
Fig. 38: Settings
Fig. 39: Adjust the Airflow preference
34
· GuardOne · Manual
®
Settings
The Settings page allows you to adjust various parameters (1) of the
GuardOne Workstation. To navigate between the screens, use the arrow
®
buttons (2) to the left and right of the main area.
Quick Start Settings
By pressing Quick Start Settings, you can replace the factory settings for the
blower and the LED lights with your preferred settings at any time during
operation.
The factory settings are:
› Blower speed is 50 %.
› LED light is turned off.
Adjusting the Airflow preference
1. Press Quick Start Settings.
2. Press the percentage value (1).
3. Select the desired airflow rate (2) using the + and - button
You can choose between 0, 50, 80 and 100 % airflow rate.
Selecting an airflow rate of 0 % will switch off the blower.
To switch it on again, either select an airflow rate above 0% or
use the Quick Start function on the Home page Chapter 6.2
"Operating the Display Area" on page 27.
4. Apply the selection using Save (3).
5. To exit the page, use Back or Home.
Exiting the page without using Save will discard all changes you
have made!
.