Signal Search; Setting The Keypad Tone / Light Mode - Oregon Scientific VIBRA Trainer Elite Mode D'emploi

SIGNAL SEARCH

To force a signal search:
1. Press MODE to navigate to the SMART TRAINING PROGRAM
or Stopwatch Mode.
2. Press and hold MODE for 2 seconds. The signal-searching
icon with the outside flashing will appear to confirm a signal
search is taking place. Whenever the watch is searching for
the chest belt signal make sure that the chest belt is no further
than 10 cm (4 inches) from the watch.
The signal search will take approximately 10 seconds. If after
10 seconds the heart icon is not flashing, then your signal search
has been unsuccessful and you need to force another signal search.
See the table in the "Transmission Signal" section for more signal
status information.

SETTING THE KEYPAD TONE / LIGHT MODE

You can set the watch to have the:
• Keypad "Beep" tone ON or OFF.
• Light Mode ON or OFF - see "Activating the Backlight" section.
To set these features:
1. Press MODE to navigate to the Real-Time Clock Mode.
14