Installing Boom And Reel Support; Installing Wire Guide Extension - Miller D-74 MPa Plus Swingarc w/Drives Manuel Du Propriétaire

5-3. Installing Boom And Reel Support

Tools Needed:
3/8, 3/4 in.

5-4. Installing Wire Guide Extension

Tools Needed:
3/8 in.
OM-254063 Page14
4
5
6
1
5
1
3
7
2
4
3
2
5
1 Swivel Plates
2 Yoke
Remove hardware from swivel
plates and yoke.
3 Boom
Set boom into swivel as shown.
4 Yoke Pin
Install pin through yoke. Install cot-
ter pin and spread ends.
5 Bolt
Install bolt, washers, and nut. Tight-
en hardware, and back bolt off one
half turn.
6 Locking Knob
Install locking knob but do not
tighten.
7 Reel Support
Install reel support.
Ref. 142804-F / 803805-C
1 Wire Guide Fitting
2 Bolt
3 Monocoil Liner
4 Wire Guide Extension
Tighten bolt to secure liner in wire
guide fitting. Do not overtighten bolt
and crush liner.
5 Blue Polymer Conduit
256380-C / 255847-A