Installing Wire Guide And Drive Roll - Miller RAD-400 Manuel D'utilisation

2-5. Installing Wire Guide And Drive Roll

6
5
3
4
2
1
Tools Needed:
1/4 in
.
When changing wire size or
type, check drive roll size (see
Table 5-1).
1 Wire Pressure Adjustment
Screw
Loosen screw to decrease tension
on spring.
2 Drive Roll Nut
3 Drive Roll Carrier
Turn nut one click to line up lobes
with lobes on drive roll carrier.
4 Drive Roll
Remove drive roll.
5 Wire Guide Securing Screw
Loosen wire guide screw.
6 Inlet Wire Guide (Supplied
With Wire Straightener Kit)
Remove inlet wire guide.
Install drive rolls, and turn drive roll
nut one click.
802 594-B
OM-1598 Page 11