Section 5 − Installation; Installing Swivel Into Pipe Post; Installing Control Box And Adjusting Tilt - Miller D-74 MPa Plus Swingarc w/Drives Manuel Du Propriétaire

5-1. Installing Swivel Into Pipe Post

Tools Needed:
3/4 in.

5-2. Installing Control Box And Adjusting Tilt

4
3
Tools Needed:
3/8 in.
SECTION 5 − INSTALLATION
2
1
1
2
!
5
1
4
2
3
Secure as shown using as a mini-
mum 1/2 in. diameter SAE grade 5
steel bolts.
4
Insert into pipe post. Lubricate
3
swivel.
5
1
2
3
Bracket and screws are installed
onto bottom of control at factory.
4
Loosen screws. Place control on
swivel and slide forward. Tighten
5
screws.
5
6
6
7
Loosen rear pivot screw. Remove
front screw. Pivot control down-
ward to desired viewing angle. Re-
7
place and tighten front screw. Tight-
en pivot screw.
Do not remove Safety Collar
until instructed to.
Swingpak Base or CBC Cart
Pipe Post With Base
Steel Bolt
Swivel Assembly
Safety Collar
152268-D
Weld Control
Bracket
Screw
Swivel
Tilt Bracket
Rear Pivot Screw
Front Screw
Ref. 252427-D
OM-254063 Page 13