Setting Of Optional Door-Entry Phone Art. 2610; Self-Ignition And Video Request Function; Privacy And Doctor Services - Comelit MT KIT 13 Manuel Technique

Setting door-entry phone (optional) Art. 2610
To extend the MAESTRO KIT system by adding the optional
door-entry phone Art. 2610, the table necessary for defining the
required door-entry phone functions is shown below.
DIP 1 DIP 2 DIP3 DIP 4
0 0 0 0
1 0 0 0
0 1 0 0
1 1 0 0
0 0 1 0
1 0 1 0
0 1 1 0
1 1 1 0
0 0 0 1
1 0 0 1
0 0 1
1
1 1 0 1
0 0 1 1
1 0 1 1
0 1 1 1
P2
2
1
P1
4
3
5 6
8
7
9
Button 1 function Button 2 function
Call
Generic actuator
to switchboard
Call Single-residence
to switchboard Inter.
Call
Two-residence Inter.
to switchboard
Single-residence
Generic actuator
Inter.
Generic actuator Two-residence Inter.
Call
Doctor
to switchboard
Doctor Generic actuator
Single-residence
Doctor
Inter.
Doctor Two-residence Inter.
Single-residence
Two-residence Inter.
Inter.
Switchboard call Automatic switch-on
Generic actuator Automatic switch-on
Doctor Automatic switch-on
Single-residence
Automatic switch-on
Inter.
Two-residence Inter. Automatic switch-on

Self-ignition and Video request function

Self-ignition function (recommended only for systems with 1 or
2 entrances). Press and immediately release the dedicated
pushbutton (pushbutton 2 - if the factory settings have been
kept) to switch on the monitor. Self-ignition is possible only
when the system is in standby.
Self-ignition can be disabled.To disable the function, press and
hold the special monitor self-ignition pushbutton for more than 6
sec. When the setting has been completed, a single
confirmation tone will sound. To enable it, press and hold the
same pushbutton for more than 4 sec. In this case, a double
confirmation tone is heard.
JP1
Video Request on monitor with brackets Art. 5914KC set as
Secondary (see JP1 in figure, in position S).
The Video Request function does not need enabling; it allows a
monitor to be switched on following a call for the user from the
external unit.
Use of Video Request function: press and immediately release
Pushbutton 2 (pay attention to the MAESTRO KIT mode set by
means of the programming microswitches) to switch on the
monitor.
JP1

Privacy and Doctor services

To activate or deactivate the Privacy or Doctor functions, press
and hold the corresponding button until the red LED lights up or
goes out.
MT KIT 13
1
S
J P
P
1
S
J P
P
37
MT KIT 13