Identification Number - Roger Technology CTRL Instructions

Identification number
The identification number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
HW version
Year of manufacture
Week of manufacture
Serial number
FW version
RS485 serial communication version
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed
Example:
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvre hours
Example:
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on
Example:
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active ( = ), parameters may be viewed but the values CANNOT be modified.
Only a single password is used to control access to the barrier automation system.
WARNING: Contact the Technical Support Service if you lose your password.
N.B.: This parameter is not visible for the SLAVE barrier.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been saved.
• Switch the control unit off and on again. Check that password protection is activated ( = ).
Temporary unlock procedure:
• Enter the password.
• Check that
Password cancellation procedure:
• Enter the password ( = ).
• Save the values
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been cancelled (the values
indicate that no password is set).
• Switch the control unit off and on again ( = ).
Password change protection
Protection deactivated.
Protection activated.
82
x100 = 1,234,500 manoeuvres
= 123 hours
= 123 days
,
buttons to view parameter
and/or DOWN
= .
, , , =
buttons to view parameter
and/or DOWN
Example:
to multiplied by 100.
to .
to .
, and .
.
.
to .
, , and and